LVC-4000.pdf

產品說明：

        The EAZY-CAL? LVC-4000 is a standalone signal conditioner,supporting a wide range of AC LVDTs, RVDTs, and VR half-bridges,while providing several choices of voltage, current, and digital RS-485 outputs. Push-button calibration offers intuitive operation as compared to signal conditioners with span and offset trim pots. Fault conditions,such as a wire break on LVDT/RVDT connections, are indicated by blinking LEDs, fault condition error output, and Error Flag Open Collector signal (see manual for details). The LVC-4000 operates from a 9-30V DC power supply and is housed in a polyamide DIN railmounted enclosure. Calibration instructions, terminal functions, LVDT connection diagram and DIP switch functions are printed on the side panels for convenience.

        Synchronization to other signal conditioners is accomplished by a daisy chain connection to a synchronization bus. One unit will assume the Master function based on DIP switch priority setting. If a fault should occur, the next highest priority unit will take over as Master.

        With the use of the RS-485 port, a host computer is able to retrieve measurement data, receive operational status, perform remote calibration, and perform hot swap reconfiguration.

技術指標：

類       型：  LVDT/RVDT信號調節模塊  

頻       率：  2.5, 5, 7.5，10 kHz  
輸       出：  0～5VDC, 0～10VDC, 0.5～4.5VDC, ±5VDC, ±10VDC，4～20 mA  
工作溫度：  -20℃～75℃  
供電電源：  9～30VDC
電氣連接：  電纜 
特       點：  DIN軌道安裝，RS485接口，主/從機勵磁同步 
典型應用：  氣體、蒸汽輪機控制系統，紙張網前箱控制